How to Resolve HP Printer Stuck on Initializing Issue?

Are you using the HP printer? Facing trouble in printing the documents? Struggling with HP printer stuck on initializing issue? Thinking about how to troubleshoot HP printers stuck on initializing issues? Well, if you are the one who is looking for the answer to these questions then don’t fret! You have landed in the right spot. You don’t need to go anywhere else. Here, in this blog, we have described the simple step-by-step instructions that assists you in resolving the HP printer stuck on initialization issue. Scroll down and check out the steps carefully. 

Troubleshoot HP Printer Stuck on Initializing Issue

Most of the users face the printer getting stuck on initializing issues with their laserjet printer due to which they are unable to print the documents. This issue can easily be resolved by performing the advanced reset. Follow the below steps to perform the hard reset on your HP printer to fix the printer stuck on initializing issue:

Step 1: The first step is to ensure that your HP printer is connected to the power outlet directly. Make sure that there is not any surge protector. 

Step 2: To perform the hard reset on the HP printer, remove the toner from it.

Step 3: Also, remove the ink cartridge from your printer. 

Step 4: After that, turn off your HP printer and disconnect the power cord.

Step 5: Thereafter, unplug the USB cable or any cable if present.

Step 6: Now, you have to wait for some time and after that, press and hold the power button on your HP printer for about 30 seconds. 

Step 7: Next, you can plug back the power cable again to the socket directly without using any extra extensions or protector extension cord. Plug in the power cord again to your HP printer.

Step 8: Turn on your HP printer and wait for some time until the initial reboot is done successfully. 

Step 9: Insert the cartridge and toner. Try to print the document to check whether the issue is resolved or not.

Ways to Avoid HP Printer Stuck on Initialization Issue 

Look at the below steps to know the ways by which you can avoid the HP printer stuck on initialization issue so that you will never face this challenge in future with your printer. Here’s are the steps:

Step 1: The first step is to turn off your HP printer. Also, unplug the USB cable, network cable and the power cable for almost 30 seconds. 

Step 2: After that turn on your printer again by plugging the USB cable, network cable and the power cable again to its place.

Step 3: If your printer is on then you need to click on the Copy and X button (Cancel button located above the copy button). Release the button until you see the permanent storage initialise. In case, it fails then you have to click on the right arrow and cancel button situated at the above copy button. 

Step 4: Make sure to download and install the latest available firmware on your system and apply it. For this, prefer to use the USB cable instead of using it over the network to update the firmware. 

Step 5: In case your home wireless router does not support ipv6 then you need to disable the ipv6 in the HP printer. 

Hopefully, by following the above guidelines you can easily resolve the HP printer stuck on initializing issue without any difficulty.